Hi All
There is situation, where we have 2 DP's in SCCM 2007 setup one on high bandwidth and other on low bandwidth. We are able to replicate the package in one DP with High Bandwidth { go to mange dp of that package and make the selction of one, then update dp} but not in other one with very low bandwidth.
We cannot use courier sender due to some reason
We have manually collected the folder from DP with high bandwith and copied it to the server share of the DP with low bandwidth. Now i went to the manage dp of the same package selected the DP with low bandwidth then selected it . Update the DP's for the package. When the process for content transfer from source to low bandwidth dp will begin it will check for the package for transfer, but it will find the package already available so no content transfer for software will happen. and after the policy sync for the package replication status we can see targetted =2 and successfull =2 and clients associated with low bandwidth dp will get the content from their local protected boundary.
Is the above said correct, if yes it is the correct way to do the same
I have not mentioned any preloadpkgonsite tool, can we complete the said above with preloadpkgtool only or without it also as said above
Regards Sushain KApoor